在Claude Code和OpenClaw之间为快速原型开发做出选择

If your priority is speed and minimal setup, Claude Code is probably the better choice. OpenClaw is great if you anticipate scaling or need more control down the line.

OpenClaw's documentation is very thorough, which helped me understand advanced features quickly, even if it took longer to get started.

For absolute beginners, Claude Code is more beginner-friendly, while OpenClaw might require some technical background.

I've used Claude Code extensively for rapid prototyping, and its intuitive interface really speeds up the initial phases of development. The learning curve is gentle, which is a big plus.

I've prototyped similar projects on both. Claude Code saved me time initially, but OpenClaw's flexibility saved time in iterative improvements later.

Performance-wise, both are quite comparable for small to medium prototypes. The difference becomes noticeable only in very large or computation-heavy projects.

Has anyone noticed any significant performance differences in prototypes built with these two? Speed is crucial for my use case.

I found the community support around Claude Code to be more active, which helped me troubleshoot issues faster during prototyping.

OpenClaw is pretty powerful, but I found it a bit more complex to set up initially. However, once configured, it offers more customization options which might be beneficial for complex projects.

One thing to consider is the licensing cost. Claude Code has a more affordable entry-level plan compared to OpenClaw, which could be a factor for startups.